CB Radio Schematics / Service Manuals. Do you need a HAM / CB / Scanner-Monitor radio schematics / service information to repair, modify, test or install you vintage CB radio / citizens band transceiver? We carry a good selection of schematics / service manuals for vintage CB radios. Get the best deal for Midland CB Radios 40 Channels from the largest online selection at eBay.com. Browse our daily deals for even more savings. Midland 77-092 CB Radio Transceiver With Antenna & Manual No Microphone. Top Rated Seller. C $38.75 shipping. Midland CB Radio Model 77-099 Used CB Tested/Working with Lighter power.
Hi all me and a mate bought a pair of Midland 77-099 from a well know auction site, it said that they were both in working order if not a little bit worn.. So we set about and fitted them into our Discos to be used whilst out and about green laneing etc.
My set-up is as follows:
Unit up in the roof in the map pocket powered from the interior light supply, then its a short run of RG58 cable with a clamp fit PL259 on either end, to a:
Base-loaded CB Mini Tornado Stinger Antenna
![Midland 77-099 Cb Radio Manual Midland 77-099 Cb Radio Manual](/uploads/1/2/6/3/126380812/161570994.jpg)
Power: 1000W
SWR: 1.5:1
Fitting: standard 3/8
Length: 88cm
When i do a SWR reading i hook up the meter as described in the instructions and carry out the test, turning the 'CAL' knob doesn't do anything and when i take readings on different channels the needle move ever so slightly above 1. The SWR meter is:
Moonraker SWR-100 CB meter
Frequency: 26-30MHz; impedance: 50 OHMS; connection: 2 X SO239 sockets
when i turn the Midland on when it is all connected to the antenna and not the SWR i get power and a very faint static noise if i turn the squelch to about half way, but you need to put your ear near the speaker to hear it.
![Mobile Mobile](http://cbradio.nl/alan/Midland%20Alan%2087.jpg)
I am now at a loss as to what to do next, i have been told to get the unit tested but i cant find anyone near me to take it to (Kent), can i start testing the unit myself i have a multimeter and access to some other equipment if needed, i just need a place to start really..
Thanks
Rob